CN

Service

Home > Service > FAQ > Digital Moving Head Light

Interference (light flashing)

    A.The signal line defective can be solved by replacing the new signal line

    B.The transmission signal line is too long to be resolved by reallocating the signal transmission distance

    C.The signal IC broken can be solved by replacing the signal IC

Without electricity

    A.Check whether the insurance is burned out and can be resolved by replacing the insurance

    B.Circuit board failure can be resolved by replacing the circuit board

    C.Switching power supply / transformer damage can be solved by replacing the switching power supply / transformer

Scanning does not move (XY axis does not move)

    A.The scanner board is burned out and can be covered by insurance

    B.The program IC bad can be solved by replacing the program IC

    C.There is a circuit board failure can be replaced by no power indicator circuit board to solve

Self-test error (self-test time is too long)

    A.The motor broken can be changed depending on the error message

    B.The program IC bad can be solved by replacing the program IC

    C.Circuit board failure can be resolved by replacing the circuit board

Not bright bubble

    A.The lamp is bad and can be solved by replacing the new lamp

    B.High frequency line break can be replaced by high frequency cable

    C.The ballast (or the trigger is bad) can be solved by replacing the ballast (or trigger)

    D.Circuit board failure can be resolved by replacing the circuit board

    E.The lamp is too hot to turn off the power, the bulb cools after the bubble

< 123 >